3D printing workshop by fixers.gr

colorFabb copperFill PLA Filament 1.75mm

colorFabb copperFill PLA Filament 1.75mm

Κανονική τιμή: 59,00 €

Special Price 55,00 €

Availability: Εκτός αποθέματος

3d printing with metal on your own desktop 3d printer! This amazing one of a kind filament will allow you to print with actual copper at home.
Να σας ενημερώσουμε όταν το προϊόν γίνει και πάλι διαθέσιμο;
Email
  (Θα λάβετε ένα αυτοματοποιημένο email όταν το προϊόν επιστρέψει σε στοκ)
 
Περιγραφή

Λεπτομέρειες

TIP! Depending on your set-up, 3d printer and slice software, you might see that copperFill needs a bit more flow compared to your normal PLA settings. Most plastics will show die swell when coming out of the nozzle tip, this is counteracted with specific slicer settings. Since copperFill doesn’t show a die swell such as PLA you might need to increase flow rate a bit, 4-8% was perfect for our UM2. UM original did not need any adjustments.

TIP! Sanding and polishing your parts will make the copper particles shine. Start sanding with grit 120-180 and make sure all the printed lines vanish. You’ll notice that because copperFill is easy to sand down, careful you won’t loose too much detail. Then start working your way up by following with grit 240-320 and finishing off with grit 600 - or higher. Finally we used a clean soft cloth and some copper polish to really get all of the shine out of the copper particles.

Adviced 3d printing temperature:
195-220°C

Adviced 3d print speed:
40 - 100 mm/s

Advised Heated bed
50-60°C

Build platform
nGen gives best results on a heated build platform, 75°C to about 85°C is usually needed for proper adhesion to a glass plate. Printing on a cold bed is possible but you’ll need some adhesion tools to minimize warping. 3DLac, buildTak or 3DEeze can do the trick.

Material: 

colorFabb nGen co-polyester

Diameter Tolerance:
± 0.05 mm

Density: 
1.20 g/cm3

Glass Transition Temperature:
85°C

Επιπρόσθετες πληροφορίες

Επιπρόσθετες πληροφορίες

Υλικό PLA Metal
Διάμετρος 1.75 mm
Χρώμα Χαλκός
Pantone Όχι
Μήκος Όχι
Μάζα 750g
Όγκος Όχι
Καρούλι Ναι
Θερμοκρασία ακροφυσίου 195-220°C
Θερμοκρασία επιφάνειας 50-60°C
Ταχύτητα εκτύπωσης 40 - 100 mm/s
Αξιολογήσεις
Συννημένα αρχεία

Product Attachments

View FileTDS copperFill    Size: (538.89 KB) Technical Data Sheet